A. Engine Stop Switch
B. START/STOP Switch (for Stop Watch)
C. Starter Button
In addition to the ignition switch,
the engine stop switch must be in
the
position for the motorcycle to
operate.
The engine stop switch is for emergency use. If required, move the switch to the position.
NOTE
Although the engine stop switch stops the engine, it does not turn off all the electrical circuits. Ordinarily, the ignition switch should be used to stop the engine.
Meter Unit Circuit (ZX1000K Model)
1. Ignition Switch
2. Joint Connector F
3. Stop Watch Button
4. Oil Pressure Switch
5. Crankshaft Sensor
6. Water Temperature Sensor
7. Gear Position Switch
8. Intake Air Temperature Sensor
9. ESD ECU (ZX1000JD/KD)
10. ECU
11. Rear Wheel Rotation Sensor
12. Frame Ground 1
13. Engine ...
Windshield
Windshield Removal
Remove:
Bolts [A] and Washers
Windshield [B]
Windshield Installation
Be sure to install the wellnuts [A] and the washers.
Tighten:
Torque - Windshield Mounting Bolts: 1.2 N·m (0.12 kgf·m,
11 in·lb)
...
Rear Wheel Rotation Sensor Signal Abnormal (Service Code b 44)
Measure the air gap between the rear wheel rotation sensor
and sensor rotor.
Thickness Gauge [A]
Air Gap
Standard: 0.4 1.6 mm (0.02
0.06 in.)
If the measurement is not the standard, check each part
for deformation and looseness and correct accordingly.
If the measurement is the sta ...