ESD Actuator Resistance Connections: BK lead [1] ←→ O lead [3] R lead [2] ←→Y lead [4] Standard: About 23 29 Ω
If the reading is out of the standard, replace the electronic steering damper unit.
If the reading is within the standard, check the input voltage (see Idle ESD Actuator Input Voltage Inspection).
Vehicle-down Sensor Installation
Be sure to install the rubber dampers [A] and collars [B]
on the bracket.
The UP mark [A] of the sensor should face upward.
WARNINGIncorrect installation of the vehicle-down
sensor
could cause sudden loss of engine power. The
rider could lose balance during certain ...
Air Suction System Damage Inspection
Separate the air switching valve hose [A] from the lower
air cleaner housing [B] (see Air Cleaner Housing Removal
in the Fuel System (DFI) chapter).
Connect the following parts temporarily.
Fuel Pump Lead Connector [A]
Extension Tube [B]
Air Cleaner Housing (see Air Cleaner Hou ...
Starter Motor Disassembly
Remove the starter motor (see Starter Motor Removal).
Take off the starter motor through bolts [A] and remove
the both end covers [B].
Pull out the armature [A] out of the yoke [B].
NOTE
Do not remove the circlip [C] from the shaft.
Remove the starter motor terminal lock ...