Kawasaki Ninja Service Manual: Exhaust Butterfly Valve Actuator Sensor (Service Code 34)

Oxygen Sensor - not activated (Service Code 33, Equipped Models)

Oxygen Sensor Removal/Installation Refer to the Oxygen Sensor Removal/Installation (Equipped Models) in the Electrical System chapter. Oxygen Sensor Inspection Remove: Fuel Tank (see Fuel Tan ...

Exhaust Butterfly Valve Actuator Sensor Input Voltage Inspection

NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the front seat (see Front Seat Removal in the Frame chapter). Remove the screws [A] and the exhaust butter ...

Other materials:

Balancer Assemble
Apply molybdenum disulfide oil solution to the ribs of the balancer [A]. Apply molybdenum disulfide oil solution to the ribs of the balancer gear [A]. Check that the rubber dampers [B] are in place. Face the linked portion [C] to the bottom. Assemble the balancer weight ...

Swingarm Bearing Removal
Remove: Swingarm (see Swingarm Removal) Collar [A] Oil Seals [B] Sleeve [C] Circlip [D] (Right Side) Special Tool - Inside Circlip Pliers: 57001-143 Remove the ball bearing and needle bearings. Special Tool - Oil Seal & Bearing Remover [A]: 57001-1058 ...

Engine Oil
In order for the engine, transmission, and clutch to function properly, maintain the engine oil at the proper level, and change the oil and replace the oil filter in accordance with the Periodic Maintenance Chart. Not only do dirt and metal particles collect in the oil, but the oil itself los ...