41.7° ±7° [B]
This position is original position of the pulley.
NOTE
Correct the position electrically after confirming the use is discontinued and there is no damage when differing from the angle of shown in the figure.
NOTICE
Do not correct the pulley position with the tool, forcibly. The actuator damage will occur.
If the angle is wrong, adjust the pulley (see Exhaust Butterfly Valve Actuator Installation in the Self-Diagnosis System chapter).
Open Cable (White) [A] Close Cable (Black) [B]
First, install the close cable (black) [A].
Second, install the open cable (white) [B].
Third, install the clamp [C].
Fourth, stretch the open cable (white) by using the adjuster [D].
Turn the adjuster counterclockwise until the play of the open cable becomes no play.
NOTICE
To keep the correct exhaust butterfly valve position, be sure to adjust the open cable first. Do not overstretch the cable.
Fifth, tighten the adjuster locknut (white) of the open cable securely.
Sixth, stretch the close cable (black) by using the adjuster [E].
Turn the adjuster counterclockwise until the play of the close cable becomes no play.
Seventh, turn the adjuster of the close cable (black) clockwise by 1/2 to 1 rotation.
Lastly, tighten the adjuster locknut (black) of the close cable securely.
Front Wheel Rotation Sensor Wiring Inspection (Service Code b 43)
Disconnect the front wheel rotation sensor lead connector
[A] (see Front Wheel Rotation Sensor Removal in the
Brakes chapter).
Disconnect the KIBS hydraulic unit lead connector (see
KIBS Hydraulic Unit Removal in the Brakes chapter).
Check the wiring continuity of the W lead and ...
Separator Operation Test
WARNINGGasoline is extremely flammable and can be
explosive
under certain conditions. Turn the ignition
switch OFF. Do not smoke. Make sure the area is
well-ventilated and free from any source of flame
or sparks; this includes any appliance with a pilot
light.
...
Cylinder Compression Measurement
NOTE
Use the battery which is fully charged.
Warm up the engine thoroughly.
Stop the engine.
Remove the spark plugs (see Spark Plug Replacement in
the Periodic Maintenance chapter).
Attach the compression gauge [A] and adapter [B] firmly
into the spark plug hole.
Using the startermo ...