Kawasaki Ninja Service Manual: Exhaust Butterfly Valve Cable Removal

Kawasaki Ninja Service Manual / Engine Top End / Muffler / Exhaust Butterfly Valve Cable Removal

Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter).
Open the clamp [A] and free the cables.
Slide the dust covers [B].

Exhaust Butterfly Valve Cable Removal

Loosen the locknuts [A], and turn the adjusters [B] to give the cable plenty of play.

Exhaust Butterfly Valve Cable Removal

Remove the clamp [A].
Remove the upper ends [B] of the exhaust butterfly valve cables from the pulley [C].

Exhaust Butterfly Valve Cable Removal

Remove the muffler body cover (see Muffler Body Removal).
Remove the bolt [A] and pulley cover [B].

Exhaust Butterfly Valve Cable Removal

Remove: Clamp [A] Screw [B] and Stopper [C] (ZX1000J model) Bolt [D] (ZX1000J model) Bolts [E] ZX1000J [F] ZX1000K [G]

Exhaust Butterfly Valve Cable Removal

Loosen the locknuts [A].
Remove the lower ends of the exhaust butterfly valve cables from the pulley [B].
Pull the exhaust butterfly valve cables out of the frame.

Exhaust Butterfly Valve Cable Removal

Exhaust Pipe Installation

Replace the exhaust pipe gaskets [A] and premuffler chamber gasket [B] with new ones. Install the premuffler chamber gasket to the premuffler chamber [C] until it is bottomed so that the cham ...

Exhaust Butterfly Valve Cable Installation

Confirm whether pulley [A] is an angle shown in the figure. 41.7° ±7° [B] This position is original position of the pulley. NOTE Correct the position electrically after confirming the u ...

Other materials:

DFI System
1. ECU 2. Battery 3. Vehicle-down Sensor 4. Exhaust Butterfly Valve Actuator 5. Vacuum Chamber (Other than US, CA and CAL Models) 6. Air Intake Valve Actuator (Other than US, CA and CAL Models) 7. Air Intake Valve (Other than US, CA and CAL Models) 8. Air Flow 9. Air Intake Solenoid Valve ...

Warning Symbols
: The red warning indicator light and the oil pressure warning symbol ( ) goes on whenever the oil pressure is dangerously low or the ignition switch is in the “ON” position with the engine not running, and go off when the engine oil pressure is high enough. Refer to the Mainten ...

Storage
Preparation for Storage Clean the entire vehicle thoroughly Run the engine for about five minutes to warm the oil, shut it off, and drain the engine oil. WARNINGEngine oil is a toxic substance. Dispose of used oil properly. Contact your local authorities for approved disp ...