14. Thermostat
15. Frame No. JKAZXT00JJA003074
or JKAZXCJ1
BA003074
G: Apply grease.
HG: Apply high-temperature grease.
L: Apply a non-permanent locking agent.
R: Replacement Parts
S: Follow the specified tightening sequence.
W: Apply water.
1. US, CA and CAL Models
2. Frame No. JKAZXT00JJA003074
or JKAZXCJ1
BA003074
3. Engine No. ZXT00JE003022
L: Apply a non-permanent locking agent.
System Components
1. FI ECU
The FI ECU analyzes the motorcycle conditions based
on the signals from the front/rear wheel rotation sensors
and FI sensors (such as the crankshaft sensor and main
throttle sensor), and controls engine power by reducing the
number of ignition and retarding the ignition timing. The
m ...
Water Temperature Sensor Inspection
Remove the water temperature sensor (see Water Temperature
Sensor Removal/Installation in the Fuel System
(DFI) chapter).
Suspend the sensor [A] in a container of coolant so that
the temperature-sensing projection [C] is submerged.
Suspend an accurate thermometer [B] with temperature
...
Air Switching Valve (Service Code 64)
Air Switching Valve Removal/Installation
Refer to the Air Switching Valve Removal/Installation in
the Engine Top End chapter.
Air Switching Valve Inspection
Refer to the Air Switching Valve Unit Test in the Electrical
System chapter.
If the air switching valve [A] is normal, check ...