EO: Apply engine oil.
G: Apply grease.
L: Apply a non-permanent locking agent.
Lh: Left-hand Threads MO: Apply molybdenum disulfide oil solution.
(mixture of the engine oil and molybdenum disulfide grease in a weight ratio 10:1) R: Replacement Parts S: Follow the specified tightening sequence.
SS: Apply silicone sealant.
Engine Sprocket Installation
Replace the sprocket washer and axle cotter pin.
Install the engine sprocket onto the output shaft.
Apply molybdenum disulfide oil solution to the threads
and seating surface of the engine sprocket nut.
Tighten:
Torque - Engine Sprocket Nut: 145 N·m (14.8 kgf·m, 107
ft·lb)
NOTE
...
Ignition System
WARNINGThe ignition system produces extremely
high voltage.
Do not touch the spark plug, ignition coil or ignition
coil lead while the engine is running, or you
could receive a severe electrical shock.
NOTICE
Do not disconnect the battery cables or any other
electrical ...
Meter Unit Circuit (ZX1000J Model)
1. Ignition Switch
2. Joint Connector F
3. Stop Watch Button
4. Oil Pressure Switch
5. Crankshaft Sensor
6. Water Temperature Sensor
7. Gear Position Switch
8. Intake Air Temperature Sensor
9. ESD ECU (ZX1000JD/KD)
10. ECU
11. Rear Wheel Rotation Sensor
12. Engine Ground
13. Battery ...