HG: Apply high-temperature grease.
HO: Apply heavy oil.
L: Apply a non-permanent locking agent.
MO: Apply molybdenum disulfide oil solution.
(mixture of the engine oil and molybdenum disulfide grease in a weight ratio 10:1) R: Replacement Parts
Specifications
Special Tools
Inside Circlip Pliers: 57001-143
Bearing Driver Set: 57001-1129
Evaporative Emission Control System Inspection (CAL and SEA-B1 Models)
Inspect the canister as follows.
Remove the upper fairing assembly (see Upper Fairing
Assembly Removal in the Frame chapter).
Remove the canister [A].
Visually inspect the canister for cracks or other damage.
If the canister has any cracks or bad damage, replace it
with a new one.
NO ...
Handlebar Installation
Apply a non-permanent locking agent to the threads of
the handlebar positioning bolts and tighten them.
Torque - Handlebar Positioning Bolts: 9.8 N·m (1.0 kgf·m,
87 in·lb)
Install the steering stem head with handlebars.
Install the washer [A] and steering stem head nut [B].
Tighten:
...
Front Caliper Removal
Remove:
Bolt [A]
Front Wheel Rotation Sensor [B]
Loosen the banjo bolt [C] at the brake hose lower end,
and tighten it loosely.
Unscrew the caliper mounting bolts [D], and detach the
caliper [E] from the disc.
NOTICE
Do not loosen the caliper assembly bolts [F]. Take
out only ...