5. Other than US, CA, and CAL Models 6. The big diameter side of the dampers faces upward.
G: Apply grease.
L: Apply a non-permanent locking agent.
R: Replacement Parts S: Follow the specified tightening sequence.
SS: Apply silicone sealant.
11. Immobilizer Amplifier (Equipped Models) 12. CAL and SEA-B1 Models
13. Other than US, CA and CAL Models
14. ZX1000J Model
15. ZX1000K Model
G: Apply grease.
L: Apply a non-permanent locking agent.
R: Replacement Parts
Specifications
Connecting Rod Twist Inspection
With the big-end arbor [A] still on V block [C], hold the
connecting rod horizontally and measure the amount that
the arbor [B] varies from being paralleled with the surface
plate over a 100 mm (3.94 in.) length of the arbor to determine
the amount of connecting rod twist.
If the conne ...
Upper Crankcase Assembly
When installing the breather plate, replace the gasket [A]
with a new one.
Apply a non-permanent locking agent to the threads of
the bolts [A] and tighten them.
Torque - Breather Plate Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Install the fitting [A] until it is bottomed ...
Oil Pump Installation
Install the outer rotor [A] into the crankcase.
Assemble:
Oil (Water) Pump Shaft [B]
Pin [C]
Inner Rotor [D]
To prevent dropping, apply grease to the pin.
Install the inner rotor assembly into the crankcase.
Fit the slot [E] onto the projection [F].
Replace the O-ring [A ...