If the shaft is bent, straighten or replace it.
If the serration [B] are damaged, replace the shaft.
If the spring [C] is damaged in any way, replace it.
If the shift mechanism arm [D] is damaged in any way, replace the shaft.
If the ratchet [A], pawls [B], pins [C] or springs [D] are damaged in any way, replace them.
If it is loose, unscrew it, apply a non-permanent locking agent to the threads, and tighten it.
Torque - Shift Shaft Return Spring Pin: 29 N·m (3.0 kgf·m, 21 ft·lb)
If the lever or spring are damaged in any way, replace them.
If they are badly worn or if they show any damage, replace it.
Check 3-3: High Beam Indicator Light (LED) Inspection
Connect the leads in the same circuit as Check 3-2.
Connect the terminal [7] to the battery (+) terminal.
Check that the high beam indicator light (LED) [A] goes
on.
If the indicator light does not go on, replace the meter unit.
...
Vehicle-down Sensor Installation
Be sure to install the rubber dampers [A] and collars [B]
on the bracket.
The UP mark [A] of the sensor should face upward.
WARNINGIncorrect installation of the vehicle-down
sensor
could cause sudden loss of engine power. The
rider could lose balance during certain ...
Rear Fender Front Removal
Remove:
Flap and Rear Fender Rear (see Flap and Rear Fender
Rear Removal)
Fuel Tank (see Fuel Tank Removal in the Fuel System
(DFI) chapter)
Battery (see Battery Removal in the Electrical System
chapter)
Exhaust Butterfly Valve Actuator (see Exhaust Butterfly
Valve Actuator Remova ...