Fit the pawls [D] and the grooves [E].
Turn the shift ratchet assembly while pushing the pawls.
Tighten the lower bolt first, and then tighten the upper one.
Tighten the lower bolt first, and then tighten the upper one.
Special Tool - Outside Circlip Pliers: 57001-144
Fit the circlip into the groove of the shift shaft securely.
Oxygen Sensor Heater Resistance Inspection
Turn the ignition switch to OFF.
Remove the fuel tank (see Fuel Tank Removal in the Fuel
System (DFI) chapter).
Disconnect the oxygen sensor lead connector [A].
Connect a digital meter [A] to the terminals in the oxygen
sensor lead connector [B].
Measure the oxygen sensor heat ...
Camshaft, Camshaft Cap Wear Inspection
Remove the camshaft caps (see Camshaft Removal).
Cut the strips of plastigage (press gauge) to journal width.
Place a strip on each journal parallel to the camshaft installed
in the correct position.
Tighten the camshaft cap bolts and upper camshaft chain
guide bolts to the specified ...
Headlight Bulb Replacement
Turn the cover [A] counterclockwise, and remove it.
Disconnect the headlight connector [A].
Open the clamp [B], and remove the bulb.
NOTICE
When handling the quartz-halogen bulb, never
touch the glass portion with bare hands. Always
use a clean cloth. Oil contamination from hand ...