Kawasaki Ninja Service Manual: Final Drive

Kawasaki Ninja Service Manual / Periodic Maintenance / Periodic Maintenance Procedures / Final Drive

Wheel Bearing Damage Inspection
Raise the front wheel off the ground with the jack (see Front Wheel Removal in the Wheels/Tires chapter). Special Tools - Jack: 57001-1238 Jack Attachment: 57001-1608 Turn the handlebar a ...

Drive Chain Lubrication Condition Inspection
If a special lubricant is not available, a heavy oil such as SAE 90 is preferred to a lighter oil because it will stay on the chain longer and provide better lubrication. If the chain appears ...

Other materials:

Oil Cooler Removal
Remove: Coolant (Drain, see Coolant Change in the Periodic Maintenance chapter) Engine Oil (Drain, see Engine Oil Change in the Periodic Maintenance chapter) Lower Fairings (see Lower Fairing Removal in the Frame chapter) Water Hose Ends [A] (Disconnect) Remove: Oil Cool ...

Blank Key Detection (Service Code 36, Equipped Models)
Ignition Key Inspection Register the ignition key correctly (see Key Registration in the Electrical System chapter). If the service code 36 appears again, the transponder in the key is malfunction, replace it. Immobilizer System Circuit 1. ECU 2. Ignition Switch 3. Immobilizer Ampl ...

Tie-Rod and Rocker Arm Bearing Installation
Replace the needle bearings [A] and oil seals with new ones. Apply plenty of grease to the lips of the oil seals. Install the needle bearings and oil seals position as shown in the figure. Screw the needle bearing driver into the driver holder. Insert the needle bearing driver into th ...