Kawasaki Ninja Service Manual: Flap and Rear Fender Rear Removal

Kawasaki Ninja Service Manual / Frame / Fenders / Flap and Rear Fender Rear Removal

Remove: Front and Rear Seat (see Front/Rear Seat Removal) Seat Covers (see Seat Cover Removal) Vehicle-down Sensor Connector [A] Screws [B]
Clear the seat lock cable [C] from the seat lock unit [D].
Take off the seat lock unit and the bracket.

Flap and Rear Fender Rear Removal

Remove: Bolts [A] (Both Sides) Bolt [B] (Both Sides) Quick Rivets [C]
Pull the flap and rear fender rear off the rear fender front.

Flap and Rear Fender Rear Removal

Disconnect: License Plate Light Lead Connector [A] Rear Turn Signal Light Lead Connectors [B] Tail/Brake Light Connector [C]

Flap and Rear Fender Rear Removal

Remove: Bolts [A] and Bracket Flap [B] Lower Pipe [C]

Flap and Rear Fender Rear Removal

Remove the bolts [A] and the brackets [B].
Pull out the upper pipes.
Remove the bolt [C], and take off the rear fender rear from the tool kit case [D].

Flap and Rear Fender Rear Removal

Front Fender Removal

Remove: Bolts [A] with Washers (Both Sides) Reflectors (Both Sides, US, CA, CAL and AU Models) Front Fender [B] Take the brake hose off the clamp [C] (both sides). Front Fender Insta ...

Flap and Rear Fender Rear Installation

Installation is the reverse of removal. Note the following. Fit the tab [A] to the slot [B]. Run the seat lock cable [C] between the tool kit case and the turn signal light as shown in the fig ...

Other materials:

Exhaust Butterfly Valve Actuator Sensor Resistance Inspection
Turn the ignition switch to OFF. Disconnect the exhaust butterfly valve actuator sensor connector (3 pins connector) [A] (see Exhaust Butterfly Valve Actuator Sensor Input Voltage Inspection). Connect a digital meter [B] to the exhaust butterfly valve actuator sensor connector. Measur ...

Handlebar Installation
Apply a non-permanent locking agent to the threads of the handlebar positioning bolts and tighten them. Torque - Handlebar Positioning Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb) Install the steering stem head with handlebars. Install the washer [A] and steering stem head nut [B]. Tighten: ...

Radiator Hose and O-ring Replacement
Drain the coolant (see Coolant Change). Remove: Upper Fairing Assembly (see Upper Fairing Assembly Removal in the Frame chapter) Thermostat Housing [A] (see Thermostat Removal in the Cooling System chapter) Oil Cooler [B] (see Oil Cooler Removal in the Engine Lubrication System chap ...