Kawasaki Ninja Service Manual: For Primary Fuel Injectors

Kawasaki Ninja Service Manual / Fuel System (DFI) / Fuel Injectors / Fuel Injector Resistance Inspection / For Primary Fuel Injectors

For Primary Fuel Injectors


Fuel Injector Resistance Inspection


Primary Fuel Injector Resistance Standard: About 11.7 12.3 Ω at 20°C
(68°F)

Fuel Injector Resistance Inspection
...

For Secondary Fuel Injectors
Remove the fuel tank (see Fuel Tank Removal). Disconnect the secondary fuel injector connector [A]. Connect a digitalmeter to the terminals in each secondary fuel injector [A]. Meas ...

Other materials:

Brake Lever Adjuster
There is an adjuster on the brake lever. The adjuster has 6 positions so that the released lever position can be adjusted to suit the operator’s hands. Push the lever forward and turn the adjuster to align the number with the mark on the lever holder. The distance from the grip to the rel ...

Release Shaft Installation
Apply grease to the oil seal lips on the upper ridge of the clutch cover. Apply engine oil to the needle bearings in the hole of the clutch cover. Applymolybdenum disulfide grease to the pusher-holding portion [A] on the release shaft. Install the washer [B] and spring [C]. ...

Spring Preload Adjustment
The spring preload adjuster is located at the lower end of each front fork leg and can be adjusted. To increase spring preload and stiffen the suspension, turn the preload adjuster clockwise with a hexagon wrench. To decrease preload and soften the suspension, turn the preload adjust ...