Secondary Fuel Injector Resistance Standard: About 11.7 ∼ 12.3 Ω at 20°C (68°F)
If the reading is out of the standard, replace the secondary fuel injector.
If the reading is within the standard, check the power source voltage (see Fuel Injector Power Source Voltage Inspection).
Crankcase Splitting
Remove the engine (see Engine Removal in the Engine
Removal/Installation chapter).
Set the engine on a clean surface and hold the engine
steady while parts are being removed.
Remove:
Cylinder Head (see Cylinder Head Removal in the Engine
Top End chapter)
Starter Motor (see Starter M ...
Mud Guard Installation
Installation is the reverse of removal. Note the following.
Run the hose and lead correctly (see Cable, Wire, and
Hose Routing section in the Appendix chapter).
Check the brake line.
Apply a non-permanent locking agent to the threads of
the mud guard mounting bolts [A, B], and tighten them ...
Inquiries to Rider
DFI Diagnosis Flow Chart
Each rider reacts to problems in different ways, so it is important to
confirm what kind of symptoms
the rider has encountered.
Try to find out exactly what problem occurred under exactly what
conditions by asking the rider;
knowing this information may h ...