Kawasaki Ninja Service Manual: Frame

Kawasaki Ninja Service Manual / Frame / Frame

Rear Fender Front Installation
Installation is the reverse of removal. Note the following. Run the harness, cables and leads correctly (see Cable, Wire, and Hose Routing section in the Appendix chapter). When install ...

Rear Frame Rear Removal
Remove: Flap and Rear Fender Rear (see Flap and Rear Fender Rear Removal) Rear Frame Rear Bolts [A] Rear Frame Rear [B] Rear Frame Rear Installation Apply a non-permanent locking agent to ...

Other materials:

Clutch Lever Installation
Install the clutch lever so that the mating surface [A] of the clutch lever clamp is aligned with the punch mark [B] of the handlebar. Tighten the upper clamp bolt first, and then the lower clamp bolt. Torque - Clutch Lever Clamp Bolts: 7.8 N·m (0.80 kgf·m, 69 in·lb) There will be ...

Lower Crankcase Assembly
Install the ball bearing [A] and the oil level inspection window [B] until they are bottomed Apply soap and water solution to the oil level inspection window before installation. Install the new circlip [C]. Apply a non-permanent locking agent to the oil passage plug [D]. Tighten: ...

Drive Chain Removal/Installation
NOTE Since the drive chain is installed through the swingarm, The chain can not be removed other than by cutting it. Prepare the new link pin, link plate, grease seals, and tools for rejoining the chain. Remove: Bolts [A] Front Footpeg Bracket [B] Remove: Bolts [A] Chain Cover [B] ...