Kawasaki Ninja Service Manual: Front Caliper Removal - Calipers

Do not loosen the caliper assembly bolts [F]. Take out only the caliper mounting bolts for caliper removal.

If the caliper is to be disassembled after removal and if compressed air is not available, disassemble the caliper before the brake hose is removed (see Caliper Rubber Parts Replacement in the Periodic Maintenance chapter).

Rear Caliper Removal

Remove: Bolt [A] Rear Wheel Rotation Sensor [B] Loosen the banjo bolt [C] at the brake hose lower end, and tighten it loosely. Loosen the caliper holder pin [D]. Remove the rear wheel ( ...

Other materials:

Front Wheel Removal
Remove: Front Caliper Mounting Bolts [A] (Both Sides) Front Caliper [B] (Both Sides) Loosen: Front Axle Clamp Bolts [A] (Right Side) Front Axle [B] Remove the lower fairings (see Lower Fairing Removal in the Frame chapter). Raise the front wheel off the ground. ...

Transmission Shaft Disassembly
Remove the transmission shafts (see Transmission Shaft Removal). Remove the circlips, and then disassemble the transmission shafts. Special Tool - Outside Circlip Pliers: 57001-144 The 5th gear [A] on the output shaft has three steel balls assembled into it for the positive neutral fin ...

Lower Fairing Installation
Installation is the reverse of removal. Note the following. When installing the pad [A], align the edge of the pad and the marking of the fairing [B]. When installing the pad [C], align the edge of the pad and the fairing [D], and fit the edge of the pad to the boss [E]. Insert the hoo ...