Kawasaki Ninja Owners Manual: Front Fork Inspection

Kawasaki Ninja Owners Manual / Maintenance and adjustment / Front Fork / Front Fork Inspection

Holding the brake lever, pump the front fork up and down several times to inspect smooth stroke.
Visually inspect the front fork for oil leakage, scoring or scratches on the outer surface of the inner tube.
If any doubt about the front fork, it should be checked by an authorized Kawasaki dealer.

A. Inner Tube

Front Fork

The front fork operation and oil leakage should be checked in accordance with the Periodic Maintenance Chart. For various riding or load conditions the front fork can be adjusted for: Spring ...

Spring Preload Adjustment

The spring preload adjuster is located at the lower end of each front fork leg and can be adjusted. To increase spring preload and stiffen the suspension, turn the preload adjuster clockwise ...

Other materials:

Exhaust Device
This motorcycle is equipped with a exhaust device system. This system controls the valve in the exhaust pipe and produces stable engine power at low and middle engine speed. This exhaust device is controlled by the ECU, and adjustment or maintenance should be done only by a competent mechanic ...

Sprocket Wear Inspection
Visually inspect the engine and rear sprocket teeth for wear and damage. If the teeth are worn as illustrated, replace the sprocket, and inspect the drive chain wear (see Drive Chain Wear Inspection in the Periodic Maintenance chapter). Worn Tooth (Engine Sprocket) [A] Worn Tooth (Rear ...

Check 3-7 Stop Watch Inspection
Connect the leads in the same circuit as Check 3-2. By pushing the upper button each time to set the stop watch mode. Connect the insulated auxiliary lead processed insulation to the terminal [13] as shown in the figure, then stop watch start to count. While count the stop watch, conn ...