Kawasaki Ninja Service Manual: Front Fork Removal (Each Fork Leg)

Kawasaki Ninja Service Manual / Suspension / Front Fork / Front Fork Removal (Each Fork Leg)

Loosen the front fork top plug [A] beforehand if the fork leg is to be disassembled.

Special Tool - Top Plug Wrench (45 mm) [B]: 57001-1741

Front Fork Removal (Each Fork Leg)

NOTE

Loosen the top plug after loosening the handlebar clamp bolt [C] and upper front fork clamp bolt [D].

Remove: Upper Fairing Assembly (see Upper Fairing Assembly Removal in the Frame chapter) Front Wheel (see Front Wheel Removal in the Wheels/Tires chapter) Front Fender (see Front Fender Removal in the Frame chapter)
Loosen: Handlebar Clamp Bolt [A] Upper Front Fork Clamp Bolt [B] Lower Front Fork Clamp Bolts [C]
With a twisting motion, work the fork leg down and out.

Front Fork Removal (Each Fork Leg)

Spring Preload Adjustment

To adjust the spring preload, turn the spring preload adjuster [A]. The standard adjuster setting is the 6 turns in from the fully counterclockwise position. WARNINGIf both adjusters ...

Front Fork Installation (Each Fork Leg)

Install the fork so that the top plug end [A] as shown in the figure. 11 mm (0.43 in.) [B] Steering Stem Head [C] Tighten: Torque - Front Fork Clamp Bolts (Lower): 23 N·m (2.3 kgf·m, ...

Other materials:

Serial number locations
The engine and frame serial numbers are used to register the motorcycle. They are the only means of identifying your particular machine from others of the same model type. These serial numbers may be needed by your dealer when ordering parts. In the event of theft, the investigating authoriti ...

Wheel/Tire Damage Inspection
Remove any imbedded stones [A] or other foreign particles [B] from tread. Visually inspect the tire for cracks and cuts, and replace the tire if necessary. Swelling or high spots indicate internal damage, requiring tire replacement. Visually inspect the wheel for cracks, cuts and dents ...

Master Cylinder Rubber Parts Replacement
Front Master Cylinder Disassembly Remove the front master cylinder (see Front Master Cylinder Removal in the Brakes chapter). Remove the seal cover [A], circlip [B], connector [C] and O-ring [D]. Special Tool - Inside Circlip Pliers: 57001-143 Unscrew the locknut [E] and pivot bolt ...