Kawasaki Ninja Service Manual: Front Forks/Rear Shock Absorber Operation Inspection

Kawasaki Ninja Service Manual / Periodic Maintenance / Periodic Maintenance Procedures / Suspension / Front Forks/Rear Shock Absorber Operation Inspection

If the forks do not smoothly or noise is found, inspect the fork oil level or fork clamps (see Front Fork Oil Change in the Suspension chapter).

Front Forks/Rear Shock Absorber Operation Inspection


Front Forks/Rear Shock Absorber Operation Inspection


If the shock absorber does not smoothly stroke or noise is found, inspect the oil leak (see Rear Shock Absorber Oil Leak Inspection).

Front Fork Oil Leak Inspection

Front Fork Oil Leak Inspection


Replace any defective parts, if necessary.

Rear Shock Absorber Oil Leak Inspection

Rear Shock Absorber Oil Leak Inspection


If the oil leakage is found on it, replace the shock absorber with a new one.

Suspension
...

Rocker Arm Operation Inspection
Pump the seat down and up 4 or 5 times, and inspect the smooth stroke. If the rocker arm [A] does not smoothly stroke or noise is found, inspect the fasteners and bearings (see Tie-Rod/Rocke ...

Other materials:

Compression Damping Force Adjustment
There are two adjustments you can make to the compression damping force. High Speed Compression Damping Adjuster [A] Low Speed Compression Damping Adjuster [B] To adjust the high speed compression damping force, turn the outside damping adjuster with a wrench to the desired position ...

Valve Guide Removal
Remove: Valve (see Valve Removal) Oil Seal Spring Seat Heat the area around the valve guide to 120 150°C (248 302°F), and hammer lightly on the valve guide arbor [A] to remove the guide from the top of the head. NOTICE Do not heat the cylinder head with a torch. This ...

Piston Ring Thickness Inspection
Measure the piston ring thickness. Use the micrometer to measure at several points around the ring. Piston Ring Thickness Standard: Top [A] 0.77 0.79 mm (0.0303 0.0311 in.) Second [B] 0.78 0.79 mm (0.0307 0.0311 in.) Service Limit: Top 0.70 mm (0.0276 in.) Second 0.71 mm (0.0280 ...