Kawasaki Ninja Service Manual: Front Wheel Rotation Sensor Removal

Kawasaki Ninja Service Manual / Brakes / KIBS (Equipped Models) / Front Wheel Rotation Sensor Removal

NOTICE

The wheel rotation sensor should be handled carefully, never struck sharply, as with a hammer, or allowed to fall on a hard surface since the wheel rotation sensor is precision made. Be careful not to get water or mud on the wheel rotation sensor.

Do not try to disassemble or repair the wheel rotation sensor.

Remove: Right Upper Inner Fairing (see Upper Inner Fairing Removal in the Frame chapter) Connector [A] (Disconnect)

Front Wheel Rotation Sensor Removal

Clear the sensor lead from the clamps [A].

Headlight Mounting Bolt [B]
Remove: Bolt [C] Front Wheel Rotation Sensor [D]

Front Wheel Rotation Sensor Removal

Front Wheel Rotation Sensor Installation

Installation is the reverse of removal.

Run the lead correctly (see Cable, Wire, and Hose Routing section in the Appendix chapter).

KIBS Hydraulic Unit Inspection

Remove the KIBS hydraulic unit (see KIBS Hydraulic Unit Removal). Visually inspect the connector terminals [A]. Replace the KIBS hydraulic unit or main harness if either of the terminals ar ...

Rear Wheel Rotation Sensor Removal

NOTICE The wheel rotation sensor should be handled carefully, never struck sharply, as with a hammer, or allowed to fall on a hard surface since the wheel rotation sensor is precision made. Be car ...

Other materials:

Subthrottle Sensor Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the air cleaner housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter) Disconnect the subthrottle sensor connector and connect the harness adapter [A] between these connectors. Spec ...

Intake Air Temperature Meter
Intake air temperature meter indicates temperature of the air in the air cleaner case. The “Intake Air” is displayed if the intake air temperature meter is selected. A. Intake Air Temperature Meter B. “Intake Air” NOTE The intake air temperature meter shift to the coolant temp ...

Idle Speed Control Valve Actuator Resistance Inspection
Turn the ignition switch to OFF. Remove the air cleaner housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter). Disconnect the idle speed control valve actuator connector [A]. Connect a digital meter to the idle speed control valve actuator connector [A] ...