Thickness Gauge [A]
Air Gap
Standard: 0.4 1.6 mm (0.02
0.06 in.)
If the measurement is not the standard, check each part for deformation and looseness and correct accordingly.
If the measurement is the standard, go to next step.
If the sensor and sensor rotor in bad condition, remove the any deposits. Install the proper part or replace faulty part.
If the all items are good, go to next step.
If this service code appears even if all checks are ended, replace the KIBS hydraulic unit.
If the service code does not appear, the KIBS system normal (temporary failure).
Spring Preload Adjustment
Remove the rear shock absorber from the frame (see
Rear Shock Absorber Removal).
Loosen the locknut and turn out the adjusting nut to free
the spring.
Special Tools - Hook Wrench T=3.2 R37: 57001-1539
Hook Wrench R=35: 57001-1580
To adjust the spring preload, turn in the adjusting n ...
Steering Damper Oil Leak Inspection
Visually inspect the steering damper [A] for oil leakage.
If the oil leakage is found on it, replace the steering
damper with a new one (see Steering Damper Removal/
Installation in the Steering chapter).
ZX1000JD/KD [B]
...
Rear Shock Absorber Inspection
Remove the rear shock absorber (see Rear Shock Absorber
Removal).
Visually inspect the following items.
Smooth Stroke
Oil Leakage
Crack or Dent
If there is any damage to the rear shock absorber, replace
it.
Visually inspect the rubber bushing [A].
If it show any signs o ...