Front Wheel Rotation Sensor Lead Connector [A] KIBS Hydraulic Unit Lead Connector [B] W Lead Terminals [C] Y Lead terminals [D]
If the wiring is open, replace or repair the harness (see KIBS System Circuit in the Brakes chapter).
If the wiring is good, go to next step.
If this service code appears even if all checks are ended, replace the front wheel rotation sensor (see Front Wheel Rotation Sensor Removal in the Brakes chapter).
If the service code does not appear, the KIBS system normal (temporary failure).
Caliper Fluid Seal Damage
The fluid seal (piston seal) [A] is placed around the piston
to maintain clearance between the pad and the disc. If
the seal is in a poor condition, it could lead the pad to wear
excessively or the brake to drag, which may cause the temperature
of the discs or the brake fluid to increase.
Re ...
Meter Unit Circuit (ZX1000K Model)
1. Ignition Switch
2. Joint Connector F
3. Stop Watch Button
4. Oil Pressure Switch
5. Crankshaft Sensor
6. Water Temperature Sensor
7. Gear Position Switch
8. Intake Air Temperature Sensor
9. ESD ECU (ZX1000JD/KD)
10. ECU
11. Rear Wheel Rotation Sensor
12. Frame Ground 1
13. Engine ...
Valve Installation
NOTICE
Do not lap the valve to the valve seat, using the
grinding compound. It will come off oxide film
treated surface of the valve.
Replace the oil seal with a new one.
Apply a thin coat of molybdenum disulfide grease to the
valve stem before valve installation.
Install the springs so ...