Kawasaki Ninja Service Manual: Fuel Injector Power Source Voltage Inspection

For Secondary Fuel Injectors

Remove the fuel tank (see Fuel Tank Removal). Disconnect the secondary fuel injector connector [A]. Connect a digitalmeter to the terminals in each secondary fuel injector [A]. Meas ...

For Primary Fuel Injectors

Remove the air cleaner housing (see Air Cleaner Housing Removal). Disconnect the injector connector and connect the harness adapter [A] between these connectors as shown in the figure. ...

Other materials:

Cam Wear Inspection
Remove the camshafts (see Camshaft Removal). Measure the height [A] of each cam with a micrometer. If the cams are worn down past the service limit, replace the camshaft. Cam Height Standard: Exhaust 35.043 35.157 mm (1.3796 1.3841 in.) Intake 38.243 38.357 mm (1.5056 1.5101 in. ...

Check 3-4: Turn Signal Indicator Light (LED) Inspection
Connect the leads in the same circuit as Check 3-2. Connect the terminal [5] to the battery (+) terminal. Connect the terminal [6] to the battery (+) terminal. Check that the turn signal indicator light (LED) [A] goes on. If the indicator light does not go on, replace the meter ...

Stopping the engine
Close the throttle completely. Shift the transmission into neutral Turn the ignition key to “OFF”. Support the motorcycle on a firm, level surface with the side stand. Lock the steering. NOTE The motorcycle is equipped with a vehicle-down sensor, which causes the engine to sto ...