NOTE
Be sure the battery is fully charged.
Main Harness [B] Fuel Pump [C]
Special Tool - Measuring Adapter: 57001-1700
Fuel Pump Operating Voltage Connections to Adapter:
Digital Meter (+) → R (pump Y/R) lead
Digital Meter (–) → BK (pump BK/W) lead
Operating Voltage Standard: Battery Voltage for 3 seconds, and then 0 V
If the reading stays on battery voltage and never shows 0 V, check the fuel pump relay (see Relay Circuit Inspection in the Electrical System chapter).
If the fuel pump relay is normal, check the ECU for its ground and power supply (see ECU Power Supply Inspection).
If the ground and power supply are good, replace the ECU (see ECU Removal/Installation).
If there is still no battery voltage, check the fuel pump relay (see Relay Circuit Inspection in the Electrical System chapter).
If the fuel pump relay is normal, check the wiring for continuity (see wiring diagram in this section).
Special Tool - Hand Tester: 57001-1394
If the wiring is good, check the ECU for its ground and power supply (see ECU Power Supply Inspection).
If the ground and power supply are good, replace the ECU (see ECU Removal/Installation).
If the reading is in specification, but the pump does not operate, replace the fuel pump (see Fuel Pump Removal/Installation).
Air Cleaner Housing Removal
Remove the fuel tank (see Fuel Tank Removal).
Disconnect the secondary fuel hose [A] from the delivery
pipe of the nozzle assy [B] (see Fuel Hose Replacement
in the Periodic Maintenance chapter).
Disconnect the secondary fuel injector connectors [C].
Free the lead from the grooves [D].
...
Alternator Cover Removal
Remove:
Upper Fairing Assembly (see Upper Fairing Assembly
Removal in the Frame chapter)
Air Cleaner Housing (see Air Cleaner Housing Removal
in the Fuel System (DFI) chapter)
Bolt [A]
Bring the heat insulator plate [B] forward to remove the
alternator lead connector.
Clear the p ...
Exhaust Pipe Removal
Remove:
Radiator (see Radiator and Radiator Fan Removal in the
Cooling System chapter)
Exhaust Pipe Clamp Bolt [A] (Loosen)
Remove the exhaust pipe holder nuts [A], and pull out the
exhaust pipe [B] forward from the premuffler chamber.
...