Kawasaki Ninja Service Manual: Fuel Pump Relay (Service Code 46)

ECU Communication Error (Service Code 39)

ECU Communication Line Inspection When the data is not sent from the ECU to the meter unit for more than about 10 seconds, the service code 39 is displayed. The data is sent through the CAN commun ...

Fuel Pump Relay Removal/Installation

The fuel pump relay is built in the relay box [A]. Refer to the Relay Box Removal in the Electrical System chapter. ...

Other materials:

Engine Oil Change
Situate the motorcycle so that it is vertical after warming up the engine. Remove the engine oil drain bolt [A] to drain the oil. The oil in the oil filter can be drained by removing the filter (see Oil Filter Replacement). Replace the drain bolt gasket [B] with a new one. Tighten t ...

Premuffler Chamber Removal
Remove: Muffler Body (see Muffler Body Removal) Right Lower Fairing (see Lower Fairing Removal in the Frame chapter) Front Seat (see Front Seat Removal in the Frame chapter) Oxygen Sensor (Equipped Models) (see Oxygen Sensor Removal (Equipped Models) in the Electrical System chapter ...

Piston Wear Inspection
Measure the outside diameter [A] of each piston 5 mm (0.20 in.) [B] up from the bottom of the piston at a right angle to the direction of the piston pin. If the measurement is under service limit, replace the piston. Piston Diameter Standard: 75.959 75.974 mm (2.9905 2.9911 in.) ...