Kawasaki Ninja Service Manual: Fuel Pump Removal

Kawasaki Ninja Service Manual / Fuel System (DFI) / Fuel Pump / Fuel Pump Removal

WARNING

Gasoline is extremely flammable and can be explosive under certain conditions, creating the potential for serious burns. Make sure the area is well-ventilated and free from any source of flame or sparks; this includes any appliance with a pilot light. Do not smoke. Turn the ignition switch OFF.

Disconnect the battery (–) terminal. To avoid fuel spills, draw it from the tank when the engine is cold. Be prepared for fuel spillage; any spilled fuel must be completely wiped up immediately.

NOTICE

Never drop the fuel pump especially on a hard surface.

Such a shock to the pump can damage it.

Be careful of fuel spillage from the fuel tank since fuel still remains in the fuel tank and fuel pump. Plug the fuel pipe of the fuel tank.

Fuel Pump Removal


NOTICE

Do not pull the leads of the fuel pump. If they are pulled, the lead terminals may be damaged.

Fuel Pump Removal


Fuel Pump
...

Fuel Pump Installation
Remove dirt or dust from the fuel pump [A] by lightly applying compressed air. Replace the fuel pump gasket with a new one. Check that the fuel pump terminal [A] and band [B] are in ...

Other materials:

Balance Inspection
Remove the front and rear wheels (see Front/Rear Wheel Removal). Support the wheel so that it can be spun freely. Spin the wheel lightly, and mark [A] the wheel at the top when the wheel stops. Repeat this procedure several times. If the wheel stops of its own accord in various positi ...

Cylinder (Upper Crankcase) Wear Inspection
Split the crankcase (see Crankcase Splitting). Remove the pistons (see Piston Removal). Assemble the cylinder (upper crankcase) [A], the cylinder head [B] and the cylinder head gasket [C]. Tighten the cylinder head bolts (see Cylinder Head Installation in the Engine Top End chapter). ...

Stem, Stem Bearing Installation
Replace the bearing outer races with new ones. Drive them into the head pipe at the same time. Special Tools - Head Pipe Outer Race Press Shaft [A]: 57001-1075 Head Pipe Outer Race Driver, 55 [B]: 57001 -1446 or Bearing Driver Set: 57001-1129 Apply grease to the outer races. ...