Connections: Battery (+) → 12 V 3.4 W Bulb (One Side) 12 V 3.4 W Bulb (Other Side) → R/BK lead [D] Battery (–) → BK/W lead [E]
If the test light turn on, the reserve switch is defective.
Replace the fuel pump.
Connections: Battery (+) → 12 V 3.4 W Bulb (One Side) 12 V 3.4 W Bulb (Other Side) → R/BK lead Battery (–) → BK/W lead
If the test light does not light, replace the fuel pump.
NOTE
It may take a long time to turn on the test light in case that the fuel reserve switch is inspected just after the fuel is drawn. Leave the fuel pump lead connector with leads for inspection connected for few minutes.
ABS Indicator Light (For models equipped with KIBS)
: Normally
the ABS indicator light goes on when the ignition switch is turned
“ON” and goes off shortly after the motorcycle starts moving. If the ABS is
normal,
it stays off. If the ABS indicator light shows any of the following, a fault or
faults may
have taken place in the ABS. You ...
Rear Wheel Rotation Sensor Signal Abnormal (Service Code b 44)
Measure the air gap between the rear wheel rotation sensor
and sensor rotor.
Thickness Gauge [A]
Air Gap
Standard: 0.4 1.6 mm (0.02
0.06 in.)
If the measurement is not the standard, check each part
for deformation and looseness and correct accordingly.
If the measurement is the sta ...
Footpeg
Footpeg Height Adjustment
The front footpeg can be adjusted within 2 positions in
height to suit the rider’s preference.
Footpeg [A]
Bolts [B]
Bolt Holes [C]
Footpeg Position 1 [D]
Footpeg Position 2 [E]
Remove the bolts [A].
Adjust the footpeg height.
NOTE
In ...