Kawasaki Ninja Owners Manual: Fuel Tank

Kawasaki Ninja Owners Manual / General information / Fuel Tank

The following octane rating gasoline is recommended for the fuel tank.

Avoid filling the tank in the rain or where heavy dust is blowing so that the fuel does not get contaminated.

Fuel Tank


A. Tank Cap

B. Fuel Tank

C. Top Level

D. Filler Neck

WARNING

Gasoline is extremely flammable and can be explosive under certain conditions, creating the potential for serious burns. Turn the ignition switch to “OFF”. Do not smoke. Make sure the area is well-ventilated and free from any source of flame or sparks; this includes any appliance with a pilot light. Never fill the tank completely to the top. If the tank is filled completely to the top, heat may cause the fuel to expand and overflow through the vents in the tank cap. After refueling, make sure the tank cap is closed securely. If gasoline is spilled on the fuel tank, wipe it off immediately.

NOTICE

California model only: Never fill the tank so the fuel level rises into the filler neck. If the tank is overfilled, heat may cause the fuel to expand and flow into the Evaporative Emission Control System resulting in hard starting and engine hesitation and in compliance with the emission regulation.

Fuel Requirement

Fuel Tank Cap
To open the fuel tank cap, pull up the key hole cover. Insert the ignition key into the fuel tank cap and turn the key to the right. To close the cap, push it down into place with the key inser ...

Fuel Type
Use clean, fresh unleaded gasoline with a minimum Antiknock Index of 90. The Antiknock Index is posted on service station pumps. The octane rating of a gasoline is a measure of its resistance t ...

Other materials:

Front Fork Installation (Each Fork Leg)
Install the fork so that the top plug end [A] as shown in the figure. 11 mm (0.43 in.) [B] Steering Stem Head [C] Tighten: Torque - Front Fork Clamp Bolts (Lower): 23 N·m (2.3 kgf·m, 17 ft·lb) NOTE Tighten the two lower front fork clamp bolts alternately two times to ensur ...

Exhaust Butterfly Valve Cable Removal
Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Open the clamp [A] and free the cables. Slide the dust covers [B]. Loosen the locknuts [A], and turn the adjusters [B] to give the cable plenty of play. Remove the clamp [A]. Remove the up ...

Exhaust Pipe Removal
Remove: Radiator (see Radiator and Radiator Fan Removal in the Cooling System chapter) Exhaust Pipe Clamp Bolt [A] (Loosen) Remove the exhaust pipe holder nuts [A], and pull out the exhaust pipe [B] forward from the premuffler chamber. ...