If the dampers are damaged or deteriorated, replace them.
Install the pad [A], hooks [B] and trim [C] on the fuel tank as shown in the figure.
[D] Attach the pad on the fuel tank so that it covers entire round from end to end.
[E] View N [F] Attach the hook parallel to this line.
[G] View L [H] Attach the hook so that the corner of it contacts the bracket.
[I] Front [J] View M [K] After installation, fix the rear end of the trim to the fuel tank by hand.
To prevent the gasoline from flowing into or out of the canister, hold the separator perpendicular to the ground.
Connect the hoses according to the diagram of the evaporative emission control system. Make sure they do not get pinched or kinked.
Run the hoses with a minimum of bending so that the air or vapor will not be obstructed.
WARNING Leaking fuel can cause a fire or explosion resulting in serious burns. Make sure the hose joint is installed correctly on the delivery pipe by sliding the joint. |
If it comes off, reinstall the hose joint.
[D] Upper Fuel Tank Cover [E] Left Fuel Tank Cover [F] Right Fuel Tank Cover [G] Attach the damper on the ruled line.
[H] Attach the hook on the ruled line.
[I] View K [J] View L
Insert the projections [A] of the upper fuel tank cover [B] into the holes [C] of the fuel tank.
Insert the hook portion [A] of the fuel tank into the slot [B] of the fuel tank cover.
Insert the projections [C] into the holes [D], and then attach the hook fastener [E] to the hook fastener [F] on the fuel tank.
Intake Air Temperature Sensor Resistance Inspection
Remove the intake air temperature sensor (see Intake Air
Temperature Sensor Removal).
Suspend the sensor [A] in a container of machine oil so
that the heat-sensitive portion is submerged.
Suspend a thermometer [B] with the heat-sensitive portion
[C] located in almost the same depth with ...
Idle Speed Control Valve Actuator Installation
Replace the O-ring [A] with a new one.
Apply engine oil to the new O-ring.
Install the idle speed control valve [A] as shown in the
figure.
10° [B]
Tighten:
Torque - Idle Speed Control Valve Actuator Retainer
Screws: 2.06 N·m (0.21 kgf·m, 18 in·lb)
Install th ...
Solenoid Valve Inspection (Service Code b 13, b 14, b 17, b 18)
The solenoid valve is built in the KIBS Hydraulic Unit [A].
Therefore the solenoid valve cannot be checked directly.
Perform the Pre-Diagnosis Inspection 1 and 2 (see Inquiries
to Rider in the Brakes chapter).
If any of these service codes appears even if all checks
are ended, replace t ...