If it is blown out, replace the fuse. Before replacing a blown fuse, always check the amperage in the affected circuit. If the amperage is equal to or greater than the fuse rating, check the wiring and related components for a short circuit.
Housing [A] Fuse Element [B] Terminals [C] Blown Element [D]
NOTICE
When replacing a fuse, be sure the new fuse matches the specified fuse rating for that circuit.
Installation of a fuse with a higher rating may cause damage to wiring and components.
Rear Master Cylinder Installation
Replace the washers that are on each side of hose fitting
with new ones.
Install the brake hose [A].
Touch the brake hose to the stopper [B] of the rear master
cylinder.
Tighten:
Torque - Brake Hose Banjo Bolt: 25 N·m (2.5 kgf·m, 18 ft·lb)
Install the master cylinder, the brack ...
Starter Clutch Assembly
Install the one-way clutch [A] to the driven gear.
Face the circlip side of the one-way clutch to inside.
Install the new snap ring [B] to the one-way clutch.
Install the drive gear [C] while turn it counterclockwise [D].
Apply molybdenum disulfide oil solution to the needle
bearing ...
Immobilizer Amplifier Replacement
Remove the upper fairing assembly (see Upper Fairing
Assembly Removal in the Frame chapter).
Disconnect the connector [A].
Pull out the immobilizer amplifier [B] together with the rubber
protector [C] from the air intake duct [D].
ECU Replacement
Refer to the ECU Removal/Instal ...