Kawasaki Ninja

Kawasaki Ninja Service Manual: Gear Position Switch Inspection

Kawasaki Ninja Service Manual / Electrical System / Switches and Sensors / Gear Position Switch Inspection

NOTE

Be sure the transmission and external shift mechanism are good condition.

Gear Position Switch Inspection


When changing the gear position from lower gear to higher gear, raise the rear wheel off the ground with the stand and rotate the rear wheel by hand.

Internal Circuit [C]

[1] LG Lead [2] G/R Lead [3] BK Lead

Special Tool - Hand Tester: 57001-1394

Gear Position Switch Inspection


Gear Position Switch Resistance


If the tester reading is not as specified, replace the gear position switch with a new one.

Gear Position Switch Installation
Securely place the springs [A] and pins [B] into the holes [C] of the shift drum. Apply grease to the new O-ring [D]. Install the gear position switch [E]. Apply a non-permanent locking age ...

Relay Box
...

Other materials:

Fuel Pump Removal
WARNINGGasoline is extremely flammable and can be explosive under certain conditions, creating the potential for serious burns. Make sure the area is well-ventilated and free from any source of flame or sparks; this includes any appliance with a pilot light. Do not smoke. T ...

DFI System
1. ECU 2. Battery 3. Vehicle-down Sensor 4. Exhaust Butterfly Valve Actuator 5. Vacuum Chamber (Other than US, CA and CAL Models) 6. Air Intake Valve Actuator (Other than US, CA and CAL Models) 7. Air Intake Valve (Other than US, CA and CAL Models) 8. Air Flow 9. Air Intake Solenoid Valve ...

Exhaust Butterfly Valve Actuator Resistance Inspection
Turn the ignition switch to OFF. Disconnect the exhaust butterfly valve actuator lead connector (2 pins connector) [A]. Set the hand tester to the × 1 Ω range and connect it to the exhaust butterfly valve actuator connector. Special Tool - Hand Tester: 57001-1394 Measure ...