Kawasaki Ninja Service Manual: Gear Position Switch Removal

Kawasaki Ninja Service Manual / Electrical System / Switches and Sensors / Gear Position Switch Removal

Remove: Oil Pump (see Oil pump Removal in the Engine Lubrication System chapter) Engine Sprocket (see Engine Sprocket Removal in the Final Drive chapter) Fuel Tank (see Fuel Tank Removal in the Fuel System (DFI) chapter)
Disconnect the connector [A].

Gear Position Switch Removal

Remove: Screws [A] Gear Position Switch [B]

Gear Position Switch Removal

Remove the pins [A] and springs from the shift drum.

Gear Position Switch Removal

Oxygen Sensor Installation (Equipped Models)

NOTICE Never drop the oxygen sensor [A] especially on a hard surface. Such a shock to the unit can damage it. Do not touch the sensing part [B] to prevent oil contact. Oil contamination from hands ...

Gear Position Switch Installation

Securely place the springs [A] and pins [B] into the holes [C] of the shift drum. Apply grease to the new O-ring [D]. Install the gear position switch [E]. Apply a non-permanent locking age ...

Other materials:

Rear Wheel Removal
Raise the rear wheel off the ground with the stand [A]. Remove: Cotter Pin [A] Rear Axle Nut [B] Washer [C] Rear Axle [D] (from Right Side) Remove the rear wheel rotation sensor from the caliper bracket (see Rear Wheel Rotation Sensor Removal in the Brakes chapter). ...

Brakes
Brake Wear Inspection Inspect the brakes for wear. For each front and rear disc brake caliper, if the thickness of either pad is less than 1 mm (0.04 in.), replace both pads in the caliper as a set. Pad replacement should be done by an authorized Kawasaki dealer. A. Lining Thickness B. ...

Unit Setting
The unit setting in the meter instrument can be changed according to local regulations. Make sure the unit setting is correctly displayed before riding. A. Speedometer B. Meter Display Units NOTE Do not operate the motorcycle with wrong unit (mph or km/h) of the speedometer. To change ...