Kawasaki Ninja

Kawasaki Ninja Owners Manual: High Speed Compression Damping Adjustment

Kawasaki Ninja Owners Manual / Maintenance and adjustment / Rear Shock Absorber / High Speed Compression Damping Adjustment

NOTICE

Do not turn the compression damping force adjuster beyond the fully seated position or the adjusting mechanism may be damaged.

High Speed Compression Damping Adjustment


A. Compression Damping Force Adjuster for High Speed

B. To increase damping force

C. To decrease damping force

Compression Damping Force Setting for High and Low Speeds

Compression Damping Force Setting for High and Low Speeds


*: This position is the fully seated position (turned fully clockwise).

**: Out from the fully seated position (turned fully clockwise). This adjustment range may not exactly match the number shown in the table due to small tolerance of production.

The standard suspension setting positions are as follows:

Standard Setting Position (Rear Shock Absorber)


*: Out from the fully seated position (turned fully clockwise)

Compression Damping Force Adjustment
The compression damping force adjusters for high and low speeds are located on the gas reservoir at the left side of the rear shock absorber. A. High Speed Adjuster B. Low Speed Adjuster NOT ...

Wheels
Tubeless tires are installed on the wheels of this motorcycle. The indications of “TUBELESS” on the tire side wall and the rim show that the tire and rim are specially designed for tubeless u ...

Other materials:

Cleaning Vehicle before Disassembly
Clean the vehicle thoroughly before disassembly. Dirt or other foreign materials entering into sealed areas during vehicle disassembly can cause excessive wear and decrease performance of the vehicle. Arrangement and Cleaning of Removed Parts Disassembled parts are easy to confuse. Arrange ...

Stick Coil Inspection
Remove the stick coils (see Stick Coil Removal). Measure the primary winding resistance [A] as follows. Connect the hand tester between the coil terminals. Set the tester to the × 1 Ω range, and read the tester. Measure the secondary winding resistance [B] as follows. Conn ...

Front Fork Oil Change
Remove the front fork (see Front Fork Removal (Each Fork Leg)). Turn the spring preload adjuster fully counterclockwise for removing the piston rod assy easily. Hold the inner tube lower end in a vise. Using the wrench [A], unscrew the top plug [B] out of the outer tube. Special Too ...