Since the hub bearings are made to extremely close tolerances, the clearance can not normally be measured.
NOTE
Do not remove any bearings for inspection. If any bearings are removed, they will need to be replaced with new ones.
If bearing play, roughness or binding is found, replace the bearing.
If the seal is torn or is leaking, replace the bearing.
Hub Bearing Lubrication
NOTE
Since the hub bearings are packed with grease and sealed, lubrication is not required.
Seat Cover Removal
Remove:
Rear Seat (see Rear Seat Removal)
Remove the bolts [A].
Remove the upper seat cover backward [B] to clear the
hook portions.
Remove:
Front Seat (see Front Seat Removal)
Quick Rivets [A]
Bolts [B]
Seat Covers [C]
...
Brake Pedal Position Adjustment
NOTE
Usually it is not necessary to adjust the pedal position,
but always adjust it when push rod locknut has been
loosened.
Loosen the locknut [A] and turn the push rod with the hex
head [B] to achieve the correct pedal position.
If the length [C] shown is 69 ±1 mm (2.7 ±0.04 in.), th ...
Lighting System
This motorcycle adopt the daylight system and have a
headlight relay in the relay box. The headlight does not
go on when the ignition switch and the engine stop switch
are first turned on. The headlight comes on after the starter
button is released and stays on until the ignition switch is
turn ...