Collars Coupling (Out of rear hub) Grease Seals
NOTICE
Do not lay the wheel on the ground with the disc facing down. This can damage or warp the disc.
Place blocks under the wheel so that the disc does not touch the ground.
Special Tools - Bearing Remover Head, 25 × 28 [B]: 57001-1346
Bearing Remover Shaft, 13 [C]: 57001 -1377
Special Tools and Sealants
Outside Circlip Pliers:
57001-144
Piston Pin Puller Assembly:
57001-910
Piston Ring Compressor Grip:
57001-1095
Piston Ring Compressor Belt, 67
79:
57001-1097
Bearing Driver Set:
57001-1129
Liquid Gasket, TB1216B:
92104-1064
Liquid Gasket, TB1207B:
92104-2068
...
Oxygen Sensor Heater Resistance Inspection
Turn the ignition switch to OFF.
Remove the fuel tank (see Fuel Tank Removal in the Fuel
System (DFI) chapter).
Disconnect the oxygen sensor lead connector [A].
Connect a digital meter [A] to the terminals in the oxygen
sensor lead connector [B].
Measure the oxygen sensor heat ...
Precautions
There are a number of important precautions that are
musts when servicing electrical systems. Learn and observe
all the rules below.
Do not reverse the battery cable connections. This will
burn out the diodes on the electrical parts.
Always check battery condition before condemning other
...