NOTICE
Never drop the idle speed control valve actuator especially on a hard surface. Such a shock to the actuator can damage it.
Hub Bearing Inspection
Since the hub bearings are made to extremely close tolerances,
the clearance can not normally be measured.
NOTE
Do not remove any bearings for inspection. If any bearings
are removed, they will need to be replaced with
new ones.
Turn each bearing in the hub back and forth [A] while
checki ...
Clutch Removal
Remove:
Clutch Cover (see Clutch Cover Removal)
Clutch Spring Bolts [A]
Clutch Springs (with Clutch Spring Holders)
Clutch Spring Plate [B]
Pusher [C]
Remove:
Friction Plates (10) [A]
Steel Plates (9) [B]
Spring [C]
Spring Seat [D]
Hold the sub clutch hub [A] ...
Front Fork Installation (Each Fork Leg)
Install the fork so that the top plug end [A] as shown in the
figure.
11 mm (0.43 in.) [B]
Steering Stem Head [C]
Tighten:
Torque - Front Fork Clamp Bolts (Lower): 23 N·m (2.3
kgf·m, 17 ft·lb)
NOTE
Tighten the two lower front fork clamp bolts alternately
two times to ensur ...