Idle Speed Control Valve Actuator Resistance Connections: G/R lead [1] ←→ G/BK lead [4] G/O lead [2] ←→ G/Y lead [3] Standard: About 64 96 Ω
If the reading is out of the standard, replace the idle speed control valve actuator.
If the reading is within the standard, check the input voltage (see Idle Speed Control Valve Actuator Input Voltage Inspection).
Oil Cooler Removal
Remove:
Coolant (Drain, see Coolant Change in the Periodic
Maintenance chapter)
Engine Oil (Drain, see Engine Oil Change in the Periodic
Maintenance chapter)
Lower Fairings (see Lower Fairing Removal in the Frame
chapter)
Water Hose Ends [A] (Disconnect)
Remove:
Oil Cool ...
Connecting Rod Big End
Bearing Insert/Crankpin Wear Inspection
Remove the connecting rod big end (see Connecting Rod
Removal).
Cut strips of plastigage to crankpin width. Place a strip
on the crankpin parallel to the crankshaft installed in the
correct position.
Tighten the connecting rod big end nuts to the specified
torque (see Connecting Rod I ...
Radiator Inspection
Remove the radiator (see Radiator and Radiator Fan Removal).
Check the radiator core.
If there are obstructions to air flow, remove them.
If the corrugated fins [A] are deformed, carefully
straighten them.
If the air passages of the radiator core are blocked more
than 20% by unremovable ...