If handlebar movement changes the idle speed, the throttle cables may be improperly adjusted or incorrectly routed, or damaged. Be sure to correct any of these conditions before riding (see Throttle Control System Inspection and Cable, Wire, and Hose Routing section in the Appendix chapter).
WARNING Operation with improperly adjusted, incorrectly routed or damaged cables could result in an unsafe riding condition. Follow the service manual to be make sure to correct any of these conditions. |
If the idle speed is out of specified range, check the idle speed control valve (see Idle Speed Control Valve Inspection in the Self-Diagnosis System chapter).
Idle Speed Standard: 1 100 В±50 r/min (rpm)
Idle Speed Adjustment
NOTE
This motorcycle is equipped with the idle speed control valve. The idle speed is adjusted automatically at the specified value (1 100 r/min (rpm)) by the idle speed control valve system. Therefore, it is not necessary to adjust the idle speed normally.
Master Cylinder Inspection (Visual Inspection)
Remove the master cylinders (see Front/Rear Master
Cylinder Removal).
Disassemble the front and rear master cylinders (see
Master Cylinder Rubber Parts Replacement in the Periodic
Maintenance chapter).
Check that there are no scratches, rust or pitting on the
inner wall [A] of each ma ...
Balancer Adjustment
Remove the left lower fairing (see Lower Fairing Removal
in the Frame chapter).
Start the engine and warm it up thoroughly.
Adjust the balancer gear backlash with the engine idling.
The amount of backlash can be changed by turning the
balancer shaft which has eccentric journals.
St ...
Exhaust Device
This motorcycle is equipped with a
exhaust device system. This system
controls the valve in the exhaust pipe
and produces stable engine power at
low and middle engine speed. This exhaust
device is controlled by the ECU,
and adjustment or maintenance should
be done only by a competent mechanic ...