Kawasaki Ninja Service Manual: Immobilizer System (Equipped Models)

Kawasaki Ninja Service Manual / Electrical System / Immobilizer System (Equipped Models)

This motorcycle is equipped with an immobilizer system to protect the motorcycle from theft. This system provides a theft proof device by means of matching a code between the inbuilt key transponder and ECU. If the code does notmatch, ignition system, injectors, subthrottle valve actuator and exhaust butterfly valve actuator will not operate and the engine will not start.

Abstract

Meter Unit Circuit (ZX1000K Model)
1. Ignition Switch 2. Joint Connector F 3. Stop Watch Button 4. Oil Pressure Switch 5. Crankshaft Sensor 6. Water Temperature Sensor 7. Gear Position Switch 8. Intake Air Temperature Sensor ...

Operational Cautions
1. Do not put two keys of any immobilizer system on the same key ring. 2. Do not submerge any key in water. 3. Do not expose any key to excessively high temperature. 4. Do not place any key c ...

Other materials:

ESD Actuator Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Disconnect the ESD actuator connector and connect a suitable measuring leads [A] between these connectors as shown. Main Harness [B] ESD Actuator [C] Connect the peak voltage adapter [D] and a digital ...

Oil Seal, Grease Seal
Do not remove pressed oil or grease seals unless removal is necessary. Replace with new ones whenever removed. Press new oil seals with manufacture and size marks facing out. Make sure the seal is aligned properly when installing. Apply specified grease to the lip of seal before installing ...

Caliper Rubber Parts Replacement
Front Caliper Disassembly Remove: Front Caliper (see Front Caliper Removal in the Brakes chapter) Brake Pads (see Front Brake Pad Removal in the Brakes chapter) Remove: Front Caliper Assembly Bolts [A] Split the front caliper. Remove: Pad Spring O-ring [A] U ...