Kawasaki Ninja Service Manual: Intake Air Pressure Sensor #1 (Service Code 12)

Main Throttle Sensor Output Voltage Inspection

Measure the output voltage at the main throttle sensor in the same way as input voltage inspection, note the following. Disconnect the main throttle sensor connector and connect the setting a ...

Intake Air Pressure Sensor #1 Removal

NOTICE Never drop the intake air pressure sensor #1 especially on a hard surface. Such a shock to the sensor can damage it. Remove: Air Cleaner Housing (see Air Cleaner Housing Removal in t ...

Other materials:

Compression Damping Force Adjuster and Rebound Damping Force Adjuster Adjustment
The compression damping force adjuster and the rebound damping force adjuster are located on top of each front fork leg. Turn the adjuster clockwise with a screwdriver to increase damping force. Turn the adjuster counterclockwise to decrease damping force. NOTICE Do not force to t ...

Front Brake Pad Installation
Check that the pad spring [A] is in place on the caliper. Push the caliper pistons in by hand as far as they will go. Install the brake pads [A] on the pad spring correctly. Fit the pad into the groove of the caliper as shown in the figure. Install the pad pins while pushing t ...

Steering Damper Removal
ZX1000JC/KC Remove: Steering Damper Mounting Bolts (TORX Bolts) [A] Washer [B] Washer and Collar [C] Steering Damper [D] ZX1000JD/KD Remove: Clamp [A] Connector [B] (Disconnect) Steering Damper Mounting Bolts (TORX Bolts) [C] Washer [D] Washer and Collar [E] Elect ...