Kawasaki Ninja Service Manual: Intake Air Temperature Sensor Installation

Intake Air Temperature Sensor Removal

NOTICE Never drop the intake air temperature sensor especially on a hard surface. Such a shock to the sensor can damage it. Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI ...

Intake Air Temperature Sensor Output Voltage Inspection

NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Disconnect the intake air temperat ...

Other materials:

Camshaft Removal
Remove: Cylinder Head Cover (see Cylinder Head Cover Removal) Crankshaft Sensor Cover (see Crankshaft Sensor Removal in the Electrical System chapter) Using a wrench on the timing rotor bolt [A], turn the crankshaft clockwise until the line [B] (TDC mark for #1,4 pistons) on the timin ...

Check 3-5: Warning Indicator Light (Red LED) (Oil Pressure Warning) Inspection
Connect the leads in the same circuit as Check 3-2. Connect the terminal [10] to the battery (–) terminal. Check that the oil pressure warning symbol [A] and the warning indicator light (Red LED) [B] go on. If the indicator light does not go on, replace the meter unit. ...

Clutch Installation
Apply engine oil to the needle bearing [A] and the sleeve [B]. Install: Needle Bearing Sleeve Install the clutch housing [A]. Fit the holes [B] and projections [C]. Engage the clutch housing gear and the crankshaft primary gear. Install the spacer [A] and the clutch ...