KIBS Hydraulic Unit Communication Line Inspection
When the data (for status of KIBS hydraulic unit) is not sent from the KIBS hydraulic unit to the meter unit and ECU, the service code 1b is displayed.
The data is sent through the CAN communication line.
The service code 1b is detected with the meter unit.
The FI symbol does not appear in this error code.
When the service code 1b [A] is detected, the ABS indicator light (LED) [B] goes on and the code of 1b displayed on the LCD.
Special Tool - Hand Tester: 57001-1394
Wiring Inspection KIBS Hydraulic Unit Connector [A] ←→ Meter Unit Connector [B] GY/BL lead (KIBS Hydraulic Unit terminal 2) [C] LB lead (KIBS Hydraulic Unit terminal 11) [D]
If the wiring is good, replace the KIBS hydraulic unit (see KIBS Hydraulic Unit Removal/Installation in the Brakes chapter).
KIBS Hydraulic Unit Communication Line Circuit
1. ECU
2. Joint Connector D
3. Joint Connector C
4. Meter Unit
5. ABS Indicator Light (LED)
6. KIBS Hydraulic Unit
General Information
All rights reserved. No parts of this publication may be reproduced, stored
in a retrieval system, or
transmitted in any form or by any means, electronic mechanical photocopying,
recording or otherwise,
without the prior written permission of Quality Assurance Division/Motorcycle &
Engin ...
Exhaust Butterfly Valve Cable Installation
Confirm whether pulley [A] is an angle shown in the figure.
41.7° ±7° [B]
This position is original position of the pulley.
NOTE
Correct the position electrically after confirming the use
is discontinued and there is no damage when differing
from the angle of shown in the figure.
...
Brake Disc Installation
Install the brake disc on the wheel so that the marked side
[A] faces out.
Front Brake Discs [B]
Rear Brake Disc [C]
Apply a non-permanent locking agent to the threads of
the brake disc mounting bolts.
Tighten:
Torque - Brake Disc Mounting Bolts: 27 N·m (2.8 kgf·m, 20
...