Kawasaki Ninja Service Manual: KIBS Hydraulic Unit Installation

Kawasaki Ninja Service Manual / Brakes / KIBS (Equipped Models) / KIBS Hydraulic Unit Installation

NOTICE

Brake fluid quickly ruins painted plastic surfaces; any spilled fluid should be completely washed away immediately.

Install the KIBS hydraulic unit together with the bracket.
Before installing the brake pipe, check to see that there is no damage on the threads of the brake pipe joint nut.

If there is any damage, replace the damaged parts with new ones.

Install the brake pipes (see Cable, Wire, and Hose Routing section in the Appendix chapter).
Tighten the brake pipe joint nuts with the flare nut wrench.

Torque - Brake Pipe Joint Nuts: 18 N·m (1.8 kgf·m, 13 ft·lb)
Pull the lever [A] forward to connect the KIBS hydraulic unit connector [B].
Bleed the brake line (see Brake Line Bleeding).
Check the brake for good braking power, no brake drag, and no fluid leakage.

KIBS Hydraulic Unit Installation

KIBS Hydraulic Unit Removal

NOTICE The KIBS hydraulic unit [A] has been adjusted and set with precision at the factory. Therefore, it should be handled carefully, never struck sharply, as with a hammer, or allowed to fall on ...

KIBS Hydraulic Unit Inspection

Remove the KIBS hydraulic unit (see KIBS Hydraulic Unit Removal). Visually inspect the connector terminals [A]. Replace the KIBS hydraulic unit or main harness if either of the terminals ar ...

Other materials:

Lower Fairing Installation
Installation is the reverse of removal. Note the following. When installing the pad [A], align the edge of the pad and the marking of the fairing [B]. When installing the pad [C], align the edge of the pad and the fairing [D], and fit the edge of the pad to the boss [E]. Insert the hoo ...

Meter Unit Circuit (ZX1000K Model)
1. Ignition Switch 2. Joint Connector F 3. Stop Watch Button 4. Oil Pressure Switch 5. Crankshaft Sensor 6. Water Temperature Sensor 7. Gear Position Switch 8. Intake Air Temperature Sensor 9. ESD ECU (ZX1000JD/KD) 10. ECU 11. Rear Wheel Rotation Sensor 12. Frame Ground 1 13. Engine ...

License Plate Light Bulb Replacement
Remove: Screws [A] License Plate Light Cover [B] Pull the bulb [A] out of the socket [B]. NOTICE Do not turn the bulb. Pull the bulb out to prevent damage to the bulb. Do not use bulb rated for greater wattage than the specified value. Replace the bulb with a new one. In ...