NOTICE
Do not turn the bulb. Pull the bulb out to prevent damage to the bulb. Do not use bulb rated for greater wattage than the specified value.
Headlight/Tail Light Circuit
1. Ignition Switch
2. Joint Connector A
3. Tail/Brake Light (LED)
4. License Plate Light 12 V 5 W
5. Joint Connector B
6. Battery
7. Main Fuse 30 A
8. Starter Relay
9. Alternator
10. Regulator/Rectifier
11. Frame Grounds
12. Headlight Circuit Relay
13. Relay Box
14. Dimmer Switch
15. Passing Button
16. Headlight Relay Fuse 15 A
17. Turn Signal Relay Fuse 10 A
18. Fuse Box #1
19. Headlight (HI) 12 V 55 W
20. Headlight (LO) 12 V 55 W
21. City Light (LED)
22. High Beam Indicator Light (LED)
Front Turn Signal Light Removal
Refer to the Upper Fairing Assembly Removal.
Front Turn Signal Light Installation
Refer to the Upper Fairing Assembly Installation.
Transmission Assy Installation
Assemble the transmission assy (see Transmission Assy
Assembly).
Be sure that the dowel pins are in position.
Install the transmission assy on the crankcase.
Tighten:
Torque - Transmission Case Bolts: 20 N·m (2.0 kgf·m, 15
ft·lb)
Install:
Shift Shaft (see External Shift Mechani ...
Fuel Pressure Inspection
NOTE
Be sure the battery is fully charged.
Remove:
Fuel Tank Covers (see Fuel Tank Removal)
Fuel Tank Bolts (see Fuel Tank Removal)
Primary Fuel Hose (see Fuel Hose Replacement in the
Periodic Maintenance chapter)
Be sure to place a piece of cloth around the fuel outlet
pipe of the ...
Tire Air Pressure Inspection
Remove the air valve cap.
Measure the tire air pressure with an air pressure gauge
[A] when the tires are cold (that is, when the motorcycle
has not been ridden more than a mile during the past 3
hours).
Install the air valve cap.
Adjust the tire air pressure according to the specifi ...