Kawasaki Ninja Service Manual: Main Throttle Sensor Removal/Adjustment - Main Throttle Sensor (Service Code 11)

Do not remove or adjust the main throttle sensor [A] since it has been adjusted and set with precision at the factory.

Never drop the throttle body assy especially on a hard surface. Such a shock to themain throttle sensor can damage it.

Main Throttle Sensor Input Voltage Inspection

NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the throttle body assy (see Throttle Body Assy Removal in the Fuel System (DFI) chapter). Do not disconne ...

Other materials:

Clutch Cover Assembly
Replace the needle bearings and oil seal with new ones. NOTE Install the needle bearings so that the manufacture’s mark face out. Install the needle bearings [A] and oil seal [B] position as shown in the figure. Press the upper and lower bearings so that the bearing surface [ ...

Fuel Flow Rate Inspection
WARNINGGasoline is extremely flammable and can be explosive under certain conditions, creating the potential for serious burns. Make sure the area is well-ventilated and free from any source of flame or sparks; this includes any appliance with a pilot light. Do not smoke. T ...

Nozzle Assy Disassembly
Remove the nozzle assy (see Nozzle Assy Removal). Pull out the secondary fuel injectors [A] from the delivery pipe assy [B]. NOTE Do not damage the insertion portions of the injectors when they are pulled out from the delivery pipe assy. NOTICE Never drop the secondary fuel injecto ...