Disconnect the throttle sensor setting adapter [A] from the connector of the main harness side.
Special Tool - Throttle Sensor Setting Adapter: 57001 -1538
Connect the setting adapter [B] to the sensor connector only.
Connect a digital meter [A] to the setting adapter [B].
Main Throttle Sensor [C]
Main Throttle Sensor Resistance Connections to Adapter: W (sensor BL) lead ← → BK (sensor BR/BK) lead Standard: 4 6 kΩ
If the reading is out of the standard, replace the throttle body assy.
If the reading is within the standard, check the output voltage (see Main Throttle Sensor Output Voltage Inspection).
Exhaust Butterfly Valve Actuator Sensor Output Voltage Inspection
NOTE
Before this inspection, confirm the pulley is original
position (see Exhaust Butterfly Valve Actuator Installation).
Disconnect:
3 Pins Connector [A] (see Exhaust Butterfly Valve Actuator
Sensor Output Voltage Inspection)
2 Pins Connector [B]
Connect the harness adapter [A ...
Torque Limiter Installation
Apply molybdenum disulfide grease to the torque limiter
shaft [A].
Install the torque limiter [B], the collar [C] and the shaft.
Turn the large-hole end of the shaft to inside as shown in
the figure.
Replace the washer [D] with a new one.
Apply a non-permanent locking agent to the t ...
Caliper Installation
Install the caliper and brake hose lower end.
For the front caliper, be sure to install the collars [A].
Replace the washers on each side of hose fitting with new
ones.
Touch the brake hoses [A] to the stopper [B] of the caliper.
Front Calipers [C]
Rear Caliper [D]
Tighten:
To ...