Kawasaki Ninja Service Manual: Mechanical Seal Inspection

Water Pump Housing Assembly

NOTICE Do not reuse the mechanical seal and oil seal. Apply high-temperature grease to the new oil seal lips [A]. Press the new oil seal into the housing with a bearing driver [B] until it st ...

Radiator

...

Other materials:

KIBS Motor Relay Inspection (Service Code b 35)
Check the KIBS motor relay fuse (25 A) [A] (see Fuse Inspection in the Electrical System chapter) If the fuse is good, check the wiring continuity as follows. Disconnect: Battery Positive Cable (see Battery Removal in the Electrical System chapter) KIBS Hydraulic Unit Lead Connector (see ...

Air Switching Valve (Service Code 64)
Air Switching Valve Removal/Installation Refer to the Air Switching Valve Removal/Installation in the Engine Top End chapter. Air Switching Valve Inspection Refer to the Air Switching Valve Unit Test in the Electrical System chapter. If the air switching valve [A] is normal, check ...

Lower Fairing Installation
Installation is the reverse of removal. Note the following. When installing the pad [A], align the edge of the pad and the marking of the fairing [B]. When installing the pad [C], align the edge of the pad and the fairing [D], and fit the edge of the pad to the boss [E]. Insert the hoo ...