Check 1-1: Switching Inspection
The all LCD segments [A] appear for 3 seconds.
The warning indicator light (Red LED) [B] goes on for 3 seconds and then goes off in a moment after that goes off.
The warning indicator light (Yellow LED) [C] goes on for 3 seconds.
The fuel level (ZX1000J model) or ABS (ZX1000K model) warning indicator light (LED) [D] goes on.
The tachometer (LED) [E] blinks 3 times.
If the meter does not work, replace the meter unit.
This display is ordinary indication.
If the meter does not work, replace the meter unit.
If meter does not work, replace the meter unit.
Normal Mode [A] Race Mode [B]
NOTE
Mile/Km Display can alternate between English and metric modes (mile and km) in the digital meter. Make sure that km or mile according to local regulations is correctly displayed before riding.
If the display function does not work, replace the meter unit.
If the indicator symbol does not work, check the following parts.
S-KTRC Button (see Switch Inspection) Wiring (see Meter Unit Circuit)
If the above parts is good, replace the meter unit and/or ECU.
If the display function does not work, check the following parts.
Power Mode Button (see Switch Inspection) Wiring (see Meter Unit Circuit)
If the above parts is good, replace the meter unit and/or ECU.
Check 1-2: Gear Position Indication Inspection
The neutral indicator light (LED) [A] goes on when the transmission gear is neutral position.
(This illustration shows normal mode.)
If the display function does not work, check the following parts.
Gear Position Switch (see Gear Position Switch Inspection) Wiring (see Meter Unit Circuit)
If the above parts is good, replace the meter unit and/or ECU.
Inner Tube Inspection
Visually inspect the inner tube [A].
If there is any damage, replace the inner tube. Since
damage to the inner tube damages the oil seal, replace
the oil seal whenever the inner tube is replaced.
NOTICE
If the inner tube is badly bent or creased, replace
it. Excessive bending, followed by ...
Oil Filter Replacement
Drain the engine oil (see Engine Oil Change).
Remove the left lower fairing (see Lower Fairing Removal
in the Frame chapter).
Remove the oil filter [A] with the oil filter wrench [B].
Special Tool - Oil Filter Wrench: 57001-1249
Replace the filter with a new one.
Apply grease t ...
Exploded View
EO: Apply engine oil.
G: Apply grease.
L: Apply a non-permanent locking agent.
M: Apply molybdenum disulfide grease.
MO: Apply molybdenum disulfide oil solution.
(mixture of the engine oil and molybdenum disulfide grease in a weight ratio
10:1)
R: Replacement Parts
S: Follow the s ...