1. Ignition Switch
2. Joint Connector F
3. Stop Watch Button
4. Oil Pressure Switch
5. Crankshaft Sensor
6. Water Temperature Sensor
7. Gear Position Switch
8. Intake Air Temperature Sensor
9. ESD ECU (ZX1000JD/KD)
10. ECU
11. Rear Wheel Rotation Sensor
12. Engine Ground
13. Battery 12 V 6 Ah
14. Main Fuse 30 A
15. Fuse Box 2
16. Meter Fuse 10 A
17. Frame Ground 3
18. Frame Ground 1
19. Frame Ground 4 (ZX1000JD/KD)
20. Fuel Reserve Switch
21. Headlight Relay
22. Turn Signal Relay
23. Mode Switch
24. Dimmer Switch
25. Turn Signal Switch
26. Passing Button
27. Joint Connector D
28. Joint Connector C
29. Fuse Box 1
30. ESD Fuse 10 A (ZX1000JD/KD)
31. Turn Signal Relay Fuse 10 A
32. Brake Light/Horn Fuse 10 A
33. Headlight Relay Fuse 15 A
34. Ignition Fuse 15 A
35. Meter Unit
Radiator Hose and Pipe Inspection (coolant leak, damage, installation
condition)
The high pressure inside the radiator hose can cause
coolant to leak [A] or the hose to burst if the line is not
properly maintained.
Visually inspect the hoses for signs of deterioration.
Squeeze the hoses. A hose should not be hard and
brittle, nor should it be soft or swollen.
Repl ...
ESD (Electronic Steering Damper) ECU Communication Error (Service Code 3C,
ZX1000JD/KD)
ESD ECU Communication Line Inspection
When the data (for status of ESD system) is not sent from
the ESD ECU to the meter unit and ECU, the service code
3C is displayed.
The data is sent through the CAN communication line.
The service code 3C is detected with the meter unit.
The FI symbol does ...
Starter Clutch Installation
Replace the O-ring [A] with a new one and apply grease.
Apply molybdenum disulfide grease to the starter clutch
shaft [B].
Install:
Starter Clutch [C]
Spacer (Small Diameter) [D]
Spacer (Large Diameter) [E]
Starter Clutch Shaft
Starter Clutch Shaft Holder [F]
Turn the O-ring si ...